Jaye Heat Exchange Finned Tubular Heater is winding metal heat sink on the surface of ordinary components, compared with ordinary components to expand the heat dissipation area by 2 to 3 times. Due to the shortening of the length of the electric heater, the heat loss itself is reduced, and under...
Jaye Heater Technology Co., Ltd. is one of the most reliable manufacturers and suppliers of heat exchange finned tubular heater in China, also supports custom service. Welcome to wholesale high quality heat exchange finned tubular heater at competitive price from our factory.
Jaye Heat Exchange Finned Tubular Heater is metal heat sink is wound on the surface of ordinary components, and the heat dissipation area is expanded by 2 to 3 times compared with ordinary components. Due to the shortening of the length of the electric heater, its own heat loss is reduced. Under the same power conditions, this heat exchange finned tubular heater has the advantages of fast heating, uniform heating, good heat dissipation performance, high thermal efficiency, and long service life.
We will design products according to your needs. Products are widely used in machinery manufacturing, automobiles, textiles, food, household appliances and other industries, especially in the air-conditioning air curtain industry.
|
|
|
|
|
|
|
|
|
Notes for use.
1, The components are allowed to work under the following conditions:
The relative humidity of the air is not greater than 95%, no explosive and corrosive gases.
Working voltage should not be greater than 1.1 times the rated value, the shell should be effectively grounded.
Insulation resistance ≥ 1MΩ dielectric strength: 2KV / 1mi n
2, The electric heater should be well positioned fixed, effective heating zone must be immersed in liquid or metal solid, forbidden to burn empty. Found that the surface of the tube body scale or carbon, should be promptly removed clean and reuse, so as not to affect the heat dissipation and shorten the service life.
3, Heating fusible metal or solid nitrate, alkali, leachate, paraffin, etc., should first reduce the use of voltage, to be melted medium, before rising to the rated voltage.
4, When heating air components should be crossed evenly arranged, so that components have good heat dissipation conditions, so that the flow of air can be fully heated.
5, When heating nitrate salt should consider safety measures to prevent explosive accidents.
6, The wiring part should be placed outside the insulation layer, avoid contact with corrosive, explosive media, water; lead wire should be able to withstand the temperature of the wiring part and heating load for a long time, wiring screws tightening should be avoided when the force is too hard.
7, Components should be stored in a dry place, if the insulation resistance is lower than 1MΩ due to long-term placement, can be dried in an oven at about 200 ℃, or reduce the voltage of the electrical heating, until the recovery of insulation resistance.
8, The electric heater out of the end of the magnesium oxide powder, in the use of places to avoid contaminants and moisture infiltration, to prevent leakage accidents.
Hot Tags: heat exchange finned tubular heater, China, manufacturers, suppliers, factory, wholesale, custom, price, electric, high quality, Duct Heating Element, Finned Duct Heters Electric, Finned Heaters For Air Heat Exchangers, Finned Resistance Heater, Finned Tubular Air Heating Elements, Finned Tubular Heater For Force Air Heating
