Mar 10, 2023
The installation process of a PTC heating element on a glue gun can vary depending on the specific model and design of the glue gun. However, in general, the steps for installing a PTC heating element on a glue gun are as follows:
1-Disconnect the power source: Before installing the PTC heating element, make sure that the glue gun is unplugged and the power source is disconnected to avoid any electrical accidents.
2-Disassemble the glue gun: In order to install the PTC heating element, you may need to disassemble the glue gun. This may involve removing screws or clips that hold the glue gun together.
3-Locate the heating element: Once you have access to the inside of the glue gun, locate the heating element. The heating element may be held in place by clips or screws.
4-Remove the old heating element: Carefully remove the old heating element from the glue gun by gently pulling it out of its housing. If necessary, you may need to use a screwdriver or pliers to remove any clips or screws that hold the heating element in place.
5-Install the new PTC heating element: Place the new PTC heating element into the housing where the old heating element was located. Make sure that it is securely in place and properly aligned with any clips or screws that hold it in place.
6-Reassemble the glue gun: Once the new heating element is installed, carefully reassemble the glue gun by replacing any screws or clips that were removed in the previous steps.
7-Test the glue gun: Plug in the glue gun and turn it on to test the new PTC heating element. Allow the glue gun to heat up for a few minutes and test the glue to ensure that it is melting properly.
