Nov 13, 2026
A shipment of 338 × 338 mm mica heaters has been dispatched to a customer in France for use in 3D printing equipment. Rated at 230 V and 820 W, the heaters will be integrated into the customer's equipment.
The project highlights the importance of matching a heating component's dimensions and electrical specifications to the equipment design.
| Item | Specification |
|---|---|
| Product | Mica Heater |
| Dimensions | 338 × 338 mm |
| Rated Power | 820 W |
| Rated Voltage | 230 V |
| Equipment Application | 3D Printing |
| Destination | France |
In 3D printing equipment, heating performance depends on the heater, the heated component, insulation, sensor placement, and temperature-control system working together.
For this project, the specified 338 × 338 mm dimensions define the heater's installation footprint, while the 230 V, 820 W rating establishes its electrical requirements. Mounting and wiring must accommodate these specifications within the equipment.
The mica heater uses an electrical resistance element insulated with mica to provide heat in a flat configuration.
Key integration considerations include:
The heater's dimensions must match the designated installation area. Mounting arrangements should secure the heater while allowing for thermal expansion.
Suitable surface contact helps transfer heat effectively. The condition and flatness of the mounting surface should be checked during assembly.
A compatible sensor and controller are needed where regulated heating is required. Actual temperature performance depends on the complete assembly and operating conditions.
Wiring, connections, and protective devices must be suitable for the heater's 230 V supply and 820 W power rating.
The mica heaters measure 338 × 338 mm and are rated at 820 W, 230 V.
Yes. Other dimensions, voltages, power ratings, and connection arrangements can be reviewed against the equipment drawing and heating requirements, subject to manufacturing feasibility.
The 820 W power rating alone does not determine operating temperature. The achievable temperature depends on the heater construction, heated component, insulation, heat losses, and control system. The required temperature should be confirmed during technical review.
Please provide the heater dimensions or drawing, voltage, wattage, target temperature, mounting method, connection requirements, and quantity.
Previous: No Information
Next: JAYE HEATER Ships Silicone Rubber Heaters To An Automotive Aftermarket Equipment Customer in India
